Governor adjustment

[California]

file:///C:/Users/mabe1945/Documents/Service%20manual%20fuel%20injection%20device%202TR-2T-3T%20series.pdf

Uh Winston we can't see inside your C: drive. You likely meant to upload that ....

 

[clemsonfor]

Haha, I was going to say the same thing as California

 

[winston1]

Woops! :ashamed:

 

[1130Lilshive]

It said in the manual not to losses these screws so there must be some sort of adjustment here right?

 

[clemsonfor]

He said it said do not loosen them or a professional with proper equipment will have to calibrate it, so there for sure is some sort of adjustment possible there, but it sounds like a normal engine just has it set in the proper place and basically should not need to be touched.

 

[1130Lilshive]

He said it said do not loosen them or a professional with proper equipment will have to calibrate it, so there for sure is some sort of adjustment possible there, but it sounds like a normal engine just has it set in the proper place and basically should not need to be touched.

Well the reason I ask is I have a 3TNE68 Yanmar in a pulling tractor and I'm trying to get as much fuel through those tiny 4 mm plungers as possible. I know these plates can adjust the volume of fuel but I've studied them for hours and can't figure out how to adjust them. I know they both have to be the same so if I can figure out which way increases fuel then I'll move them both to "wide open", any help is greatly appreciated.

 

[winston1]

Page 19.

 

[1130Lilshive]

Page 19.

Winston I can't get your link to work, it's probably on my end im stuck with a phone.