Welding table overhaul
- Thread starter dzljon
- Start date
- Views: 2835
mddorange
Elite Member
- Joined
- Jul 16, 2014
- Messages
- 3,357
- Location
- Guin, AL
- Tractor
- 2014 Kubota L3200 DT w/LA524 FEL, Loaded rear tires, LP RCR 1860 5' Cutter, LP RTA 1258 5' Tiller, LP PFL 2042 Pallet Forks w/60" Extensions, KK BB60 Box Blade, KK PHD-12" Post Hole Digger
:welcome:
To the forum from Alabama. Nice looking work.
To the forum from Alabama. Nice looking work.
Shield Arc
Super Member
WOW! It's easy to see someone has a fortune tied up in tools. :licking:
kevingweq
Member
- Joined
- Jan 22, 2015
- Messages
- 26
- Location
- Sudbury Mass
- Tractor
- Power King.International TD7C,TD15B, 3 Mc/Deering T-20's JD318
Very Nice work !! What type of table is your welding project clamped to ??
OP
dzljon
Advertiser
That is a t-slot table from a big knee mill I found online for $100 original length was 6 ft and weighed about 400 lbs I cut it down to 4 ft for the overhaul project
OP
dzljon
Advertiser
OP
dzljon
Advertiser
OP
dzljon
Advertiser
Thanks
ThomasH
Gold Member
Nice looking cutting table, I wish I had one but no room. Are you going to put a height control unit on it?
