Yanmar FX32 fuses
- Thread starter Peterchris
- Start date
- Views: 4650
OP
Peterchris
Member
I filed, sanded, and wire-brushed every connection from the battery to ground and from the battery to the starter. It worked! I was able to start the tractor with the key. That you so much for the help!
YanmarFever
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 4,077
- Location
- Eating a melon..
- Tractor
- Mahindra 5010C- Branson 4520r- 5520C- Yanmar FX235-D - Bad Boy rogue mower
I had 2 FX32s with Koyker loaders for a few years, they were my favorite and the perfect size.
Keep them cables clean and tight
Keep them cables clean and tight
YanmarFever
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 4,077
- Location
- Eating a melon..
- Tractor
- Mahindra 5010C- Branson 4520r- 5520C- Yanmar FX235-D - Bad Boy rogue mower
Did you find - - -
YANMAR FX32 FX42 PARTS MANUAL NPC-1574.pdf
It will show you the information Yanmar Fever mentioned.
The FX32 & the FX42 are really the same tractors, only the 42 has a turbo charger that gives it the extra 10 hp.
ponytug
Super Member
Don't forget the higher ozone levels. I have seen wire nuts, inside a junction box, inside a building, corrode, and rust out in Hawaii.
I am a big fan of coating electrical contacts as a result. Get the surfaces super clean, and then put a layer of copper /graphite laden dielectric grease on. Tractors run on 12-14V, and it doesn't take much in the way of surface gunk/corrosion to make a contact surface non-conductive, i.e. not actually able conduct meaningful amounts of electricity due to the surface resistance. I am also a fan of re-wiring using marine grade tinned wire and marine grade heat shrink connectors with thermal glue linings. Do it once...
All the best,
Peter