Would a snow Blower from a UTV (they have their own engine) be practical to mount on
- Thread starter jobguy
- Start date
- Views: 1909
PILOON
Super Star Member
Those that I have seen are not very heavy duty.
More or less the same 'guts' as walk behinds, only wider, just look at the gear boxes.
Better off to locate a standard PTO type and power it with a suitable engine.
I recall 5 hp per foot being the requirement, in fact I did power up a 48" with a 16 hp wisconsin using sprocket and chain and it performed great.
All that said, a rear mount is probably still the best solution all around, just learn to sit sideways as you blow.
More or less the same 'guts' as walk behinds, only wider, just look at the gear boxes.
Better off to locate a standard PTO type and power it with a suitable engine.
I recall 5 hp per foot being the requirement, in fact I did power up a 48" with a 16 hp wisconsin using sprocket and chain and it performed great.
All that said, a rear mount is probably still the best solution all around, just learn to sit sideways as you blow.
leonz
Super Member
The large Berco is about 7000+- plus sales tax plus shipping or was anyway.
Your loader would not be able to handle the weight anyway.
_________________________________________________________________
Pronovost or not at all!!!:thumbsup::licking::drool:
Avondale
Platinum Member
There may also be an issue with turning radius (if that's important to the intended place it will be used), as the blower would extend well beyond the front tires.
/ Would a snow Blower from a UTV (they have their own engine) be practical to mount on
#5
