Put in shop had positive cables worked on/new battery. Was running had to stop it. Turned key nothing happen, next day turned key had to put jumping cables to start. Was running on highway tractor cut off while drivin, turn key nothing happens. Now when I turn key I’m getting nothing. What can be causing this?
Won’t turn over
- Thread starter Clafrance
- Start date
- Views: 661
LD1
Epic Contributor
Bad connection
Jerry/MT
Elite Member
- Joined
- Feb 2, 2008
- Messages
- 3,141
- Location
- North Idaho-The Palouse
- Tractor
- New Holland TD95D, Ford 4610 & Kubota M4500
Make sure your chasis ground is clean and tight. Make sure the battery terminals are clean and tight. Make sure wires to starter solenoid have voltage when you turn the key to the start position. If you don't then start looking at the safety switches to see if you have an open circuit. Check the key switch for a loose wire. Since it cut off when running, whatever controls the fuel solenoid circuit must have lost voltage. Me thinks you maybe have a loose wire/bad switch in a safety circuit or a bad ignition switch, etc..
ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 10,691
- Location
- southern wisconsin
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
Does the situation change if you install the jumpers on just the tractor? Positive goes bat to starter and neg goes to bat to good ground.
