OK, so I'm not exactly NEW to this problem on various junk cars I and my off spring have had over the decades, but I need SPECIFICS on the Kukje power wiring.
This is a 42 HP Large frame machine from 2005/06.
It is "as if" I have a poor battery connection or a weak battery.
i.e. sometimes it starts fine, other times the lights come on a bit dim but brighten up a bit once the glow plugs switch off, then NOTHING once I turn the key to start.
I have cleaned up the terminals and even replaced the battery itself, no luck.
So I chased the ground wire to the front right hand side of the frame - looks good, though I haven't yet taken it off and wire brushed it, etc.
Now to the positive (RED) wire - ANY details on where it goes to (presumably) the fuse block, starter solenoid, etc would be SO APPRECIATED !
This is a 42 HP Large frame machine from 2005/06.
It is "as if" I have a poor battery connection or a weak battery.
i.e. sometimes it starts fine, other times the lights come on a bit dim but brighten up a bit once the glow plugs switch off, then NOTHING once I turn the key to start.
I have cleaned up the terminals and even replaced the battery itself, no luck.
So I chased the ground wire to the front right hand side of the frame - looks good, though I haven't yet taken it off and wire brushed it, etc.
Now to the positive (RED) wire - ANY details on where it goes to (presumably) the fuse block, starter solenoid, etc would be SO APPRECIATED !