Who's running or has run a Tigercat M760 ?

[WestshoreConstruction]

I have a question for you if you have, did the machine seem to hang up on the relief valve or seem slow to recover ? I have the rock drum on mine and for some reason it seems to hit the relief easy and it seems slow for the attachment pump to recover.. I bumped the relief to 5300 and its a little better but still seems to hang a little too long. Oh right, FAE 500U-250 rock drum.

 

[cbturf]

I have never run an FAE but you need to check your voicemail!

 

[WestshoreConstruction]

I have never run an FAE but you need to check your voicemail!

I did buddy and you have to answer your phone lol.

 

[treeman40]

check fuel filter and acuator on turbo 10 pounds of pressure should open it .air pressure

 

[WestshoreConstruction]

check fuel filter and acuator on turbo 10 pounds of pressure should open it .air pressure

Engine runs fine, Im talking about the hydraulic motor for the mulcher.

 

[Eagleview]

I think the motor on the head will have a cross port relief valve , it may be faulty or need adjusting .

 

[treeman40]

check accumalater if it loses nitrogen it will not recover fast

 

[WestshoreConstruction]

check accumalater if it loses nitrogen it will not recover fast

It's fine, apparently according to TC it's only there to absorb spikes in the hydraulic system.

 

[treeman40]

WELL KEEP CHECKIN PRESSURES.YOU WILL FIGURE IT OUT

 

[Versatrac Industries]

look for the spike relief on the head, it should be at 800psi over the multi-function valve on you carrier. if this check valve is lower or defect the close loop is by-passing until your pressure is under the setting of that valve. good luck.