Trouble finding RH tierod for 2005 kubota L2800 DT

[clovergamecock]

I have a 2005 L2800 DT that I broke the right hand tie rod assembly. I have found several on eBay but non of them have L2800 listed. I have seen some with L2805, are those the same? I have contacted several vendors on eBay and so far non can tell me what fits.

3243 44612 New Kubota L255 L265 L285 L295 L325 L345 L365 LH Tie Rod | eBay

I am having the same problem with the fuel cap.

Suggestions???

Thanks
Wade

 

[George2615]

According to the site below the RH tie rod assy. is part #32580-44770 and is available through many sources online

Kubota L28DT / HST (Dual Traction 4wd / Hydrostatic Transmission) Parts Diagrams

Scroll down the left side and click on steering, then scroll down to tie rod and parts list pops up.

 

[LD1]

Suggestions???

Thanks
Wade

Call your dealer. No way to know if the prices you see online, are a good deal or not, without first knowing what your dealer would charge you.

Kubota parts are pretty hard to come by in the aftermarket. Lots of dealer only stuff. And when you do find stuff on ebay, it is usually either a dealer selling parts (which prices would be similar to your local dealer), or someone who ordered wrong parts and no longer needs (better prices, but not as common as dealers selling parts online).

As to the tierod....what is broke? Do you need the whole "assembly"?, or just the rod? or just one of the ball joints?

Same with the fuel cap? whats wrong with it?

I had to replace the fuel cap on my L3400. Top cracked and "pushed" out where the fuel tank pushes against the seal when tightening. The tighter you tightened the cap, the more it pushed the crack open. There were two different caps they used, so you will need to know your serial number to make sure you get the right one. Mine was the larger cap, at some point in time they went to a smaller cap.

 

[clovergamecock]

Call your dealer. No way to know if the prices you see online, are a good deal or not, without first knowing what your dealer would charge you.

Kubota parts are pretty hard to come by in the aftermarket. Lots of dealer only stuff. And when you do find stuff on ebay, it is usually either a dealer selling parts (which prices would be similar to your local dealer), or someone who ordered wrong parts and no longer needs (better prices, but not as common as dealers selling parts online).

As to the tierod....what is broke? Do you need the whole "assembly"?, or just the rod? or just one of the ball joints?

Same with the fuel cap? whats wrong with it?

I had to replace the fuel cap on my L3400. Top cracked and "pushed" out where the fuel tank pushes against the seal when tightening. The tighter you tightened the cap, the more it pushed the crack open. There were two different caps they used, so you will need to know your serial number to make sure you get the right one. Mine was the larger cap, at some point in time they went to a smaller cap.

The whole assembly is broken and the tierod ends are worn out. Grease fittings are completely rotted. So I need all of it.

The fuel cap lip is busted.