tough paint

   / tough paint #61  
If you have about an extra $60k for a good Downdraft booth, and use it properly, it can really make a difference.

I have panted a lot of parts, cars, trucks, boats, buses, trailers, outside. As you know, under the right conditions, you can get a really nice job.
 
   / tough paint #62  
I think my 1/yer hobby tractor collecting paint jobs will likely be staying out in the open unless the lottery comes in.. :)

soundguy
 
   / tough paint #63  
seems like every time I try to paint outside it will rain, flood, famine and locusts will fly out of no where and land right in the middle of the best looking panel :eek: ;) anyhow I've painted a LOT of stuff outside and or in a pole barn areas. I had a dang BIG ole spider drop down and crawl across the hood of a nice car back a while ago... it made it from almost dead center all way down to the hood ornament.. Go figure...

The last thing I painted with Liquid Paint was my Dump Wagon I built form scratch back in 02 or so. seen here are some pics dump trailer pictures by WPSPIKER - Photobucket it still looks pretty good despite a couple hundred tons of wet gravel sand wood and STUFF. The inside is starting to rust a bit now mostly due to scratches and setting with wood in it for last year on and off. the wood/bark is worse than gravel I think for increasing rust.

Mark
 
   / tough paint #64  
The "swimmers" ALWAYS end up in the middle of the hood. :thumbsup:
 
   / tough paint #65  
yep.. on a big piece you can't section and repaint.. like a side panel that has joints you can tape up..

soundguy
 

Tractor & Equipment Auctions

WOOD GRABBER FOR MINI EXCAVATOR (A58214)
WOOD GRABBER FOR...
EZ-GO Utility Cart (A55853)
EZ-GO Utility Cart...
New/Unused CFG Industrial QK18R Mini Excavator (A57453)
New/Unused CFG...
Mini Skid-Steer 60in Straight Digging Arm (New/Unused) (A59225)
Mini Skid-Steer...
LINCOLN ELECTRIC RANGER 225 GAS WELDER/GENERATOR (A54757)
LINCOLN ELECTRIC...
FORD 3PT. REVERSABLE SCOOP PAN (A52708)
FORD 3PT...
 
Top