OK I have my 276D manual and it says that I only have one valve to control lowering speed and locking the hydraulic lift. As to how to adjust drop speed it says "Turning anticlockwise, lowering speed of hydraulic lift becomes faster. Adjust dropping speed so that it is slow enough to be safe." There is also a Warning - "Excessive speed of drop may cause damage or injury. Fully lowering implement should require at least two full seconds."
looks the same on a 169d. some others have posted about the T connector beneath the seat, in the front, that's the open/close valve... and, what saltfork wrote from the manual, same in the 169d manual.
Found it to day........DID NOT know it was there...............
MY YM2000 has the identical setup as California's diagram.............2 Valves................The knob that you can clearly see, and the little lever dircetly under the seat with the "small" handle...............
...........AGAIN.........................Identical to Diagram above...........................
Hi All!
New member Greg Clark here. Thanks for this info! It is just what I was looking for. I just bought a YM2000 amd am getting my sea legs with it. The 3pt hitch was a bit of a mystery to me.
So far this forum has answered every question I had without having to even post a question!!! Great forum.