TN95 and TN85

[hotchkiss]

Does anyone know the size of the allen socket that is needed to remove the drain plug for the oil on this size tractor. I went to change the oil this weekend and didn't have the right size. But I only had a half inch with me in the larger size wrenches.

 

[RickB]

12MM.

 

[Doc_Bob]

12MM.

RickB you are the man!

 

[WTA]

Isn't that supposed to come with the tractor? A nice little common tool kit for them is supposed to be in the tool box I have bee told by one dealer. Mine had the allen wrench but nothing else. I looked in a bunch of other new tractors on the lot yesterday and all their boxes were empty.

things I recommend carrying is that 12 MM

10 mm combination wrench. (bleed screws)
13 mm combination wrench (for switching your spool valve int eh back from single acting to double acting)
15 mm combination wrench (loose banjo fittings)
17 mm combination wrench (injectors)
flat heat screwdriver both small and large ones.

 

[Wildcat Ranch]

Is it 12MM for the TN65 as well?

 

[RickB]

All TN oilpan drains as well as the 4WD planetary hub drain/fill/checks. Most, if not all TL/35 series, too.

 

[hotchkiss]

Thanks. 12mm it is then.

 

[RickB]

Isn't that supposed to come with the tractor? A nice little common tool kit for them is supposed to be in the tool box I have bee told by one dealer. Mine had the allen wrench but nothing else. I looked in a bunch of other new tractors on the lot yesterday and all their boxes were empty.

things I recommend carrying is that 12 MM

10 mm combination wrench. (bleed screws)
13 mm combination wrench (for switching your spool valve int eh back from single acting to double acting)
15 mm combination wrench (loose banjo fittings)
17 mm combination wrench (injectors)
flat heat screwdriver both small and large ones.

You don't actually think dealers leave stuff like that in tractors sitting on the lot, do you? It sure wouldn't stay there long.
Put a 22MM wrench on your list so you can check the oil in the front axle center section.