I just purchased a 2009 TK100, which is New Hollands crawler. I am having a problem with the hydraulics. There are 3 pair of female couplers and I found out that this new hydraulic coupler does not have a sleave that slides back like the old hydraulic lines do, they just snap in, and to uncouple them you just pull them out. We are trying to use the old lines that are on my disc. It appears as if the male end of the old lines do not go in far enough into the females on the tractor. Do I have to replace the old type with a new type?
TK100 hydraulics
- Thread starter dmiletich
- Start date
- Views: 1405
Robert_in_NY
Super Member
- Joined
- Aug 1, 2001
- Messages
- 8,552
- Location
- Silver Creek, NY
- Tractor
- Case-IH Farmall 45A, Kubota M8540 Narrow, New Holland TN 65, Bobcat 331, Ford 1920, 1952 John Deere M, Allis Chalmers B, Bombardier Traxter XT, Massey Harris 81RC and a John Deere 3300 combine, Cub Cadet GT1554
Go to your NH dealer and get the correct pioneer tips that NH uses. Its a pretty standard tip now. Compare it to yours and if your old tips are different replace them with the new. If the hoses are rough it may be a good time to replace a hose as well.
The tips are not that expensive, when I use my last one I buy a few extra and always keep one or two on the tractor at all times just in case I go to hook on to an implement I either didn't change before or am borrowing. And if I ever need a tip I know where they are.
The tips are not that expensive, when I use my last one I buy a few extra and always keep one or two on the tractor at all times just in case I go to hook on to an implement I either didn't change before or am borrowing. And if I ever need a tip I know where they are.
Jerry/MT
Elite Member
- Joined
- Feb 2, 2008
- Messages
- 3,141
- Location
- North Idaho-The Palouse
- Tractor
- New Holland TD95D, Ford 4610 & Kubota M4500
you most likely need new tips on the disc's lines.
