kenmac
Super Member
- Joined
- Feb 13, 2005
- Messages
- 9,833
- Location
- The Heart of Dixie
- Tractor
- McCormick CX105 Kubota MX 5100 HST, Kubota ZD1021, Kawsaki Mule 4010 trans 4x4
Anyone bought a Titan tooth bar for a Kubota with 6 ft Bucket ?
Titan Tooth Bar
- Thread starter kenmac
- Start date
- Views: 1199
Sheldon Hamblin
Bronze Member
- Joined
- Nov 4, 2010
- Messages
- 90
- Tractor
- 2016 Kioti CK2610HST with loader , 2014 John Deere X310 w/mower deck and snowblower,
I bought a tooth bar from Titan for a Kioti with a 5 ft. Bucket.
Good price, delivered with no problem. Follow up phone call to see if I was satisfied .
It was an extremely tight fit, and since I only use it occasionally I ground the edges so it was easier to mount and take off. Would be easier if I had two buckets, but I'm too cheap.
Works well for digging up roots, and in frozen ground. Other than that I use a bolt on cutting edge. The tooth bar wants to dig no matter what you are trying to do.
Lost a removable tooth pin, and thus the tooth. I emailed them, paid for the tooth, they sent me 2 pins with it.
Good price, delivered with no problem. Follow up phone call to see if I was satisfied .
It was an extremely tight fit, and since I only use it occasionally I ground the edges so it was easier to mount and take off. Would be easier if I had two buckets, but I'm too cheap.
Works well for digging up roots, and in frozen ground. Other than that I use a bolt on cutting edge. The tooth bar wants to dig no matter what you are trying to do.
Lost a removable tooth pin, and thus the tooth. I emailed them, paid for the tooth, they sent me 2 pins with it.