Flail Mower Titan Flail mower

   / Titan Flail mower #151  
   / Titan Flail mower #152  
I was thinking about it this morning, and this may be a solution.
The two upright plates attached to the deck have holes to bolt the triangle-side piece. The large pin connects the lift-arms to the two upright plates as well. The outside plate is bending and ruining everything attached.
My idea is to just connect the two plates using the existing holes with some nice grade-8 bolts. This would support the bending plate and allow me to cinch the two plates together. I though I would probably put nuts and spacers in between them as well to prevent any kind of shimmy.


flailfix1close.png
 
   / Titan Flail mower #153  
I was thinking about it this morning, and this may be a solution.
The two upright plates attached to the deck have holes to bolt the triangle-side piece. The large pin connects the lift-arms to the two upright plates as well. The outside plate is bending and ruining everything attached.
My idea is to just connect the two plates using the existing holes with some nice grade-8 bolts. This would support the bending plate and allow me to cinch the two plates together. I though I would probably put nuts and spacers in between them as well to prevent any kind of shimmy.


View attachment 665303

It will certainly help, but it may not solve the problem long term. The issue seems to be way to much flex in the uprights, leading to bending fatigue failures. The bolts will reduce the the flex some, but if it was my flail mower I would be welding horizontal braces between both uprights, front and back. One set as low as possible, and the other set mid way up. Angle iron or better, square tube.

In conjunction with the bollts I bet that would do it, and solve the a-frame issues at least.

It's not just an implement, it's a hobby ;)
 
   / Titan Flail mower #154  
It's not just an implement, it's a hobby ;)

No kidding!

You're right though, it needs more. I will have to load this thing and carry it an hour to get to a welder, but I may have to do that.
 
   / Titan Flail mower #155  
My method of adding additional steel as I showed in my upload has survived longer than the original. I don't think it will break. Adding another horizontal cross brace would also likely help and probably be easier than what I did.
 
   / Titan Flail mower #156  
Running a piece of all thread across the entire length with jamnuts at each up-right and tying all the up-rights together may give a lot of strength. If there is room, I would opt for at least 1/2" diameter all thread
 
 

Tractor & Equipment Auctions

2023 CATERPILLAR 299D3 SKID STEER (A51242)
2023 CATERPILLAR...
2023 TAKEUCHI TL10V2 SKID STEER (A51242)
2023 TAKEUCHI...
2000 Ford Ranger (A50515)
2000 Ford Ranger...
2012 MACK GU713 DUMP TRUCK (A51406)
2012 MACK GU713...
2021 Case Trident 5550 Spreader (A52128)
2021 Case Trident...
2021 Fleco DX140 24in Tooth Bucket Excavator Attachment (A49461)
2021 Fleco DX140...
 
Top