shady brook
New member
I like having the different key as well less chance anyone sneaking off with my tractor if I'm not around.
TC45DA Ignition Switch
- Thread starter Jackfr
- Start date
- Views: 30008
OP
Jackfr
Gold Member
- Joined
- May 28, 2008
- Messages
- 328
- Location
- Plymouth, MA
- Tractor
- NH WorkMaster 33 Ford F5000 NH T 4.90 Ford 2110 JD555B
Everything is fine so far with NAPA switch replacement. By now I would probably be thinking about ordering one of the NH ones for replacement. Hope it works out for you also.
ccap74
Member
Im on my third one with 620hrs. I bought the TC45DA new in 2005/6
jinman
Rest in Peace
- Joined
- Feb 23, 2001
- Messages
- 21,059
- Location
- Texas - Wise County - Sunset
- Tractor
- NHTC45D, NH LB75B, Ford Jubilee
Wow! Is it possible you are treating the symptoms rather than the problem? Something could be overloading that switch and causing it to fail from heat. Three switches would sure make me suspicious.
RDrancher
Veteran Member
Mine started acting up today (about fifteen minutes before finishing my job...go figure.) Engine shut off for no apparent reason. Turned the key and it started back up. Each time it stayed running for a shorter time. Then turning the key I got a click then no click. Faint electrical smell. Called the dealer and the service tech immediately brought up the switch and also said to check the wiring at the connection to the switch. He said that a few have caught fire at that location.
I made it to the dealership before closing to get a new switch, so we'll see how it goes in the morning.
I made it to the dealership before closing to get a new switch, so we'll see how it goes in the morning.
jinman
Rest in Peace
- Joined
- Feb 23, 2001
- Messages
- 21,059
- Location
- Texas - Wise County - Sunset
- Tractor
- NHTC45D, NH LB75B, Ford Jubilee
RDrancher
Veteran Member
No kidding Jim. :laughing: At least the boys had one in stock.
Waiting for the sun to come up so I can get the old girl going.
Waiting for the sun to come up so I can get the old girl going.
OP
Jackfr
Gold Member
- Joined
- May 28, 2008
- Messages
- 328
- Location
- Plymouth, MA
- Tractor
- NH WorkMaster 33 Ford F5000 NH T 4.90 Ford 2110 JD555B
There's a good reason they keep them in stock! After what I went through with those switches I wouldn't waste my time or money ($80+)replacing it. I'd change it to a regular Ignition switch. The NAPA one ($23)I installed is still working fine over a year later, at the rate I was replacing the NH ones I would have put two more of the NH plastic ones in by now.
pedalstomper78
Gold Member
I know that tractorhelp.com has replacement switches for those tractors as I've had to put a few in my DX33. It seems that putting the relay in much like in the sticky thread would be the ticket here also.
http://www.tractorbynet.com/forums/new-holland-owning-operating/124642-tc33d-wont-start.html
Melted ignition switches suck.
Tractors only ever break when you need them.....LOL
http://www.tractorbynet.com/forums/new-holland-owning-operating/124642-tc33d-wont-start.html
Melted ignition switches suck.
Tractors only ever break when you need them.....LOL
paul dyar
Bronze Member
Replaced mine with a regular Ignition switch.
