sunpro gauges -3110

Gizmo36 · Jul 11, 2007

I have sunpro gauges to put on my 3110 .any one that has put them on there tractor what did you use . the nylon tubing or did you get a copper line and put it on. what would be the best.

SailorBob · Jul 11, 2007

I installed the Sunpro on my YM1700 initially using the plastic tubing. After about 6 months it quite working. The tubing had a pin hole in it. I think the vibration cracked it. Go ahead and go with the copper tubing.

kenmac · Jul 11, 2007

use the copper tubing. I left my lights on. I hate where the oil sensor is on this 3110 just above the oil filter .Kinda in the way

Gizmo36 · Jul 11, 2007

141 PM , I most have done something wrong . It is bed time I will look at them tomorrow night.

SydKen · Jul 19, 2007

Did you get them installed? I have a 3000 and have been considering adding some sunpro guages for a while. I would love to see where you installed them and any advice for installing them.

Thanks.

SailorBob · Jul 19, 2007

I cut holes on the dash with a hole saw. I installled them myself. I will try to get a picture and post it. There was plenty of of room on the 1700 on the left side of the dash.

Gizmo36 · Jul 28, 2007

Sydken I have not put them in yet . but I have the copper line to use on it. I am building a trailer right now as soon I get done with it . I will put it on and put some picture on here were I put them.