Shed Project

[JDGREEN4ME]

Want to make it easier to get my tractor in the shed. Right now there is a door on the side of the shed. It would be much easier to enter from the end of the shed. Before I go and cut out the end of the shed and spend the time to construct my own doors I was wondering if anyone out there knows any one who sells pre-hung shed doors at least 6'x6', 6'x 8', etc.
Thank you,

 

[rancar]

Lowe's or Home Depot may sell some of these doors....but, to be frank you might enjoy it more if you purchase some ship lap or tongue and groove 1"x6" boards from one of these stores and make the door yourself. It's all not that hard....just a bit time consuming.

Bob

 

[s1120]

You could also look into getting a small overhead door. That is one thing I am looking for for my shed.

 

[KYFARMER]

JD, I will probably confuse you but this is an easy way to make hinged doors. On the inside, attach 2x4 or 2x6's horizonially both toward the top and the bottom of the door(s). Extend them pass the needed door(s) opening. Attach angle bracing.
On the outside, attach the hinges.
Now.......cut out the doors