johnesc
New member
I have a 2006 JD 3530, Power Beyond, FEL, BH, Grapple. This morning I lifted the brush hog, set it where I wanted to leave it and removed it. Hooked up to the 3 point stump grinder that I've used a few times with this tractor, hopped on, moved the draft lever, it didn't lift the grinder. The arms will very slowly raise but it can stop it with my hands, lowers fine fast or slow by using the knob under the seat.
The FEL up, down, curl works fine, Grapple works fine, I attached the BH (just the hydraulics) works fine, stump grinder hydraulics work fine.
Fluid is fine, not due for hydraulic filters and oil for quite some time yet.
Why would my rock shaft suddenly stop?
The FEL up, down, curl works fine, Grapple works fine, I attached the BH (just the hydraulics) works fine, stump grinder hydraulics work fine.
Fluid is fine, not due for hydraulic filters and oil for quite some time yet.
Why would my rock shaft suddenly stop?