I HAVE JUST BROUGHT A 1959 massey Ferguson. 35x with a perkins 4 cylinder diesel engine. The taco is not working no cable!! Cant see where the cable should be attached to engine/fuel pump!! Can anyone advise, cant see in workshop manual which has 400+ pages.
rev counter cable where to connect?
- Thread starter davemyatt
- Start date
- Views: 7120
BobG_in_VA
Veteran Member
- Joined
- Jul 4, 2003
- Messages
- 2,027
- Location
- Central VA, USA
- Tractor
- Mahindra 6000 MWFD, 2 1950's Farmalls, 1974 Farmall 140, 1967 Mf 135Delux
Not sure about the Perkins diesels, but the Continental engine models connected to the back of the generator and up to the tach....BobG in VA
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,896
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
Does it still have the original generator or has it been replaced?
Kenneth S
Gold Member
- Joined
- Jul 21, 2012
- Messages
- 350
- Location
- San Antonio, Texas
- Tractor
- 1965 Massey Ferguson 2135 Industrial. 1967 Massey Ferguson 135. 1996 New Holland/Ford 6640
On the 3 cylinder Perkins diesel the tach runs off the back of the camshaft above the bell housing. If it has a 4 cylinder diesel it's a Standard Diesel Company 23C 4 cylinder diesel engine then it's probably also not a 35X.
WilliamTO-35
Silver Member
While probably not relevant to this diesel powered MF , I noticed that there are aftermarket alternators available that have a tach/speedo ( tractormeter) drive on the back. I'd love to get one for my Ferguson TO-35 so I could hook up the original cable, but at around $200 I'll have to at least wait until the present alternator goes bad . ( 38 years and counting !)
