Repairing GC Series Power Steering Ram Brackets

   / Repairing GC Series Power Steering Ram Brackets
  • Thread Starter
#11  
Thanks!
 
   / Repairing GC Series Power Steering Ram Brackets #13  
I had to weld around the original hole then grind it back out until it fit properly. Then I made some reinforcements to try to hold the center ram a bit more solid.
I can’t seem to get the photo to attach..?
It’s basically just a 1/4” plate shaped slightly larger then the original ones. The center hole is a bit smaller and the outside is large enough to use the frame to help keep the ram centered. The picture is on my phone so I’ll try to post it again.
 
   / Repairing GC Series Power Steering Ram Brackets
  • Thread Starter
#15  
Got around to replacing my steering ram brackets. The right side bracket was bent allowing both sides to move around. Its not too bad of a job, just a little tedious getting up and down on my knees for a ~75 YO. I am considering replacing the right side tie rod. There appears to be no grease in any of them.

BTW, I think its a really weak design for a tractor.
 

Tractor & Equipment Auctions

2016 Ford Escape SUV (A50324)
2016 Ford Escape...
2013 MACK CHU613 (A50854)
2013 MACK CHU613...
2014 FREIGHTLINER CASCADIA TANDEM AXLE SLEEPER (A51219)
2014 FREIGHTLINER...
2020 KUBOTA RTV X1100C UTV (A51406)
2020 KUBOTA RTV...
2017 Ford F-450 Crew Cab Mason Dump Truck (A50323)
2017 Ford F-450...
John Deere 843 Corn Head (A50514)
John Deere 843...
 
Top