Ramairfreak98ss
Silver Member
How do you know if theyre set inwards or wide? Mine are about 65" from edge to edge in the rear of my 4720 with R4s... can they move out wider? My smallest bucket is a 72" so another few inches either side wont hurt.
R4 4x20 models wheel positions?
- Thread starter Ramairfreak98ss
- Start date
- Views: 978
AKfish
Super Member
- Joined
- Oct 1, 2004
- Messages
- 5,419
- Location
- Alaska
- Tractor
- JD 5115M; JD 110 TLB; JD 4720; Ford 9N; JD X300R
I have seen some models of the 4x20 series tractors with the multi-position rims and R4 tires. With those rims you (theoretically, at least) could have the wheels in 8 different positions.
Your owner's manual should refer to the various positions that the rims can be used. If you have the 2-position rims with R4's (like me) it's pretty straight-forward.
AKfish
Your owner's manual should refer to the various positions that the rims can be used. If you have the 2-position rims with R4's (like me) it's pretty straight-forward.
AKfish
dirtworksequip
Veteran Member
- Joined
- Jun 3, 2006
- Messages
- 1,463
- Location
- Wheeling, WV
- Tractor
- 2006 JD 3520 w/cab & 300CX loader. 1995 JD 870 w/440 loader & 8b backhoe.JD 455 w/54" mower deck.
If you have the regular R4 wheels and only have in or out. The widest position will be with the air valves turned in. The width gain is minimal at best, but I guess something is better than nothing.
Sincerely, Dirt
Sincerely, Dirt