Purge hydrolics

[DeeDubya]

I recently replaced a short hose on the front loader of my 2910i. As it was above most everything, I lost very little fluid when replacing it. I've got air in the system and it will not purge on it's own. Everything works but there is a hesitation when first started and jumpy thereafter. Any thoughts or remedies?

 

[4570Man]

Keep using it.

 

[Oldoak]

Raise the FEL lift arms to the maximum stoke of the cylinders and lower to the ground a couple of times, at the same time dump and retract the bucket to the full stroke of the dump cylinders while it is raised also helps to eliminate the trapped air.

 

[Texasmark]

Hydraulics will self bleed if you follow the above instructions...make take more than twice but if they were working and all you did is what you said, they will recover.