pto driveshaft wobble allowable?

   / pto driveshaft wobble allowable? #1  

agcomike

Silver Member
Joined
Apr 28, 2003
Messages
112
Location
southern states
Tractor
Hinomoto e2004 aka 5020
I was wonder how much wobble is there allowed for a 2' tiller pto shaft? I had to weld one end and now it appears to be wobbling a little. /forums/images/graemlins/blush.gif. at 540 rpm i don't see how it would hurt other than wearing out the u-joints??

thanks
 
   / pto driveshaft wobble allowable? #2  
I believe you are allowed 5/32",+ or - 1/64" /forums/images/graemlins/tongue.gif.
 
   / pto driveshaft wobble allowable? #3  
Hinomoto Mike It could also cause wear in the splines where they slip on if its real bad. You could take it to a drive line shop and they can put it in amachine and find out how much it is out of balance then they tack weld a counter weight on the otherside to correct it.
Ralph
 

Tractor & Equipment Auctions

1992 BOBCAT 743 SKID STEER (A52705)
1992 BOBCAT 743...
TOOLBOX (A53843)
TOOLBOX (A53843)
2018 Atlas Copco Pas200HF Diesel Dewatering Pump (A52377)
2018 Atlas Copco...
2007  BIG TEX 16' T/A TRASH TRAILER (A53843)
2007 BIG TEX 16'...
2023 UNVERFERTH 432 LOT NUMBER 32 (A53084)
2023 UNVERFERTH...
TOOLBOX (A53843)
TOOLBOX (A53843)
 
Top