Post Hole Digger Cart plans
- Thread starter powerscol
- Start date
- Views: 14104
foggy1111
Elite Member
I use an engine hoist (cherry picker) I bought off of Craig's List ($100) to pick mine from my 3 point. I then roll it to the corner of my shed where I hang it from a wooden support in the corner. I mostly use my cherry picker to hold my tiller. It works super for several tasks like this.
Lots of these cherry pickers available.....and they do work slick for some 3 point attachments.
Lots of these cherry pickers available.....and they do work slick for some 3 point attachments.
Atchuuu
Gold Member
- Joined
- Jan 12, 2018
- Messages
- 471
- Tractor
- Kubota L4330 HSTC
My plan as well.
Good idea. Didn't know the engine hoist would lift high enough. Any photos?
foggy1111
Elite Member
Sorry no pics. Mine seems to lift fairly high tho. I'd snap a pic for you.....but Im in AZ till May. FORE!
Atchuuu
Gold Member
- Joined
- Jan 12, 2018
- Messages
- 471
- Tractor
- Kubota L4330 HSTC
Deleted. Double post
Atchuuu
Gold Member
- Joined
- Jan 12, 2018
- Messages
- 471
- Tractor
- Kubota L4330 HSTC
Nice job. Thanks for posting. I will use this to build mine.
How do you support the auger at the top of the 2x4 frame? Can't tell from the photo but it doesn't look like the Auger is attached to the wood frame.
prof fate
Platinum Member
- Joined
- May 30, 2018
- Messages
- 684
- Location
- beaver pa
- Tractor
- kioti ck3510 Cub Cadet 149, 2146, Toro Zero Turn
Used wood that was lying round and 4.5" structural screws leftover from another project (as good as lag bolts but no pre drilling).
Need to tie it on a bit better if i don't want it to move when on the forks, but it didn't "go" anywhere.
Need to tie it on a bit better if i don't want it to move when on the forks, but it didn't "go" anywhere.
OP
powerscol
Veteran Member
Nice Job.
Where did you get the rubber tires and mounting hardware. Would solve my problem moving mine