deere36
Bronze Member
I have been intending to build a plow to plow in water pipe, wire, etc. and have borrowed one from a gentleman in a nearby town but his was very crude. Then one day I saw this idea on Kenny D's photo album and it is very simple to build using a 2 inch receiver tube and a scarifier from a box blade.
Added two pictures of plow not in ground, as you can tell I used some scrap steel for a gusset and had to fill in with welder.
I cut a 1 inch piece of 4 inch steel pipe and bend the PVC through the steel pipe and tape the PVC back to itself and hook the steel pipe over the point of the plow so the PVC stays on the bottom of the plow point, it is important to make several passes to loosen ground before burying pipe so plow goes as deep as possible.
Thanks to Kenny D and all of you guys for good ideas and suggestions
Larry
Added two pictures of plow not in ground, as you can tell I used some scrap steel for a gusset and had to fill in with welder.
I cut a 1 inch piece of 4 inch steel pipe and bend the PVC through the steel pipe and tape the PVC back to itself and hook the steel pipe over the point of the plow so the PVC stays on the bottom of the plow point, it is important to make several passes to loosen ground before burying pipe so plow goes as deep as possible.
Thanks to Kenny D and all of you guys for good ideas and suggestions
Larry
Last edited:
