tdg54
New member
Just found this site whilst looking for info on a broken Tie rod. Who knows, maybe this is something I can DIM (Do it myself) and fix.
Palatine, IL
- Thread starter tdg54
- Start date
- Views: 567
mfreund
Veteran Member
They are easy to replace. You could look on you tube. Could you post a picture of the broken one?
Basically, you loosen the castle nut on top. The stud which the nit is on is tapered into the spindle. Use a hammer to tap on the area of the spindle in which the taper is set. This is the hardest part. Once you get that separated mark the threads where the end is unscrew the body of the ball joint. Screw in the new one and then place the taper into the spindle. Tighten the castle nut, put in the cotter pin and you are done.
Basically, you loosen the castle nut on top. The stud which the nit is on is tapered into the spindle. Use a hammer to tap on the area of the spindle in which the taper is set. This is the hardest part. Once you get that separated mark the threads where the end is unscrew the body of the ball joint. Screw in the new one and then place the taper into the spindle. Tighten the castle nut, put in the cotter pin and you are done.
deerseeker001
Elite Member
- Joined
- Jul 20, 2011
- Messages
- 4,150
- Location
- Central wisconsin
- Tractor
- International 2500a with Loader
Welcome from Wisconsin
mguitas
Super Member
- Joined
- Aug 22, 2011
- Messages
- 8,080
- Location
- Schuylkill County Pennsylvania
- Tractor
- Massey Ferguson 1423 Hydrostat
:welcome:
RandyT
Elite Member
Welcome from down state.