Over charging
- Thread starter kuby
- Start date
- Views: 3697
rdln
Veteran Member
sounds like a good amount to me, A good battery before starting should read 13-15 volts, your tractors regulator keeps a starter/components from being damaged. Using the analogy of inflating a tire to 30psi from 25psi you want you airhose pressure to start at 50psi or else the tire and tank will even out to quickly, in the extreme case of a 20psi line you would be deflating the tire
slowrev
Elite Member
About the only other items that would cause overcharging would be the alternator or wiring.......Sounds like a short somewhere is causing it to charge wide open. Fix it or you will damage your battery and any electronics that your tractor might have.
Good luck, I cannot give you any specific tests as I am not familiar with Kubota charging systems, just charging systems in general.
Ben
Good luck, I cannot give you any specific tests as I am not familiar with Kubota charging systems, just charging systems in general.
Ben
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Depending on the external regulator setup.. I'd check the charge wire, for any fraying or chafing/ shorting. Another big cause of overcharging with an alternator and external vreg.. is a bad ground reference at the vr. Any voltage drop in the ground circuit of a vr will translate to the regulated voltage side as a higher charge rate.
Soundguy
Soundguy
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Charging voltage up to 15 volts is about the norm.. however.. a fully charged battery just sitteng there should not read 15 volts...
Soundguy
Soundguy
ZJ_HR
Gold Member
Normal charging voltage when engine runs is 14.4V.
Everything above this is bad, as electrolysis starts in battery, and battery is vapouring water.
When you have so high voltage, seems refulator is fail or you haven't connection to battery, or batery is dead. Where did you have measured voltage, on alternator or battery connnection?
Everything above this is bad, as electrolysis starts in battery, and battery is vapouring water.
When you have so high voltage, seems refulator is fail or you haven't connection to battery, or batery is dead. Where did you have measured voltage, on alternator or battery connnection?
