Onan twin cylinder engine electronic ignition

[60lp]

I'm trying to find electronic ignition for my Air Products model AP 200MG 6.OCCK-331E/5289L serial 0470209494 120 volt single phase 3.5KW @100% Duty Cycle 60 Cycle @ 1800 RPM I hope I give enough information all will be very appreciated also I'm needing a carburetor build kit also thanks again

 

[CincyFlyer]

Ignore the fact that you have a generator or welder or whatever, and just go for the parts for the engine. I've found some Cummins/Onan resources online; head in that direction.

 

[Imaybail]

How to: Convert ONAN CCK & MCCK 6.5KW to OEM Electronic Ignition - SmokStak
Lots of info on old motors on this forum.

Onan Parts.Com, Rebuild Parts for Onan engines
Appliance Parts | Replacement Water Filters | Lawn & Garden Repair Parts
Should find your operator manual and parts manual here:
Index of /~nnas/manuals/onan

 

[buickanddeere]

A generic Pertronic kit. Aluminum collar with a pellet magnet is slid onto the crank and held with an Allen key grub screw. Fasten the detection/switching module to clear the collar by 20 thou. Connect the Pertronix to a dual output coil with a matching primary winding. There are Pertronix for 3.0okm could and a Pertronix II for coils with resistance down to 0.3 or 0.5ohms range .