idaho2
Gold Member
- Joined
- Aug 11, 2009
- Messages
- 422
- Location
- SW WA / North Idaho
- Tractor
- Mahindra 5530 4WD Turbo - Gear,
What size tractor are you planning on using with the plow?
Old Plow broke
- Thread starter otherguy
- Start date
- Views: 4743
The tractor is 45hp
HarryVanderpool
Gold Member
That looks like a total piece of cake to repair.
Remove the U-bolts and the shaft.
Cut everything away from the broken end except for the shaft.
Buy a piece of 2 x 3/4" cold roll.
Cut to length, drill the hole for the pin, then weld it on.
Eassy peezy.
Remove the U-bolts and the shaft.
Cut everything away from the broken end except for the shaft.
Buy a piece of 2 x 3/4" cold roll.
Cut to length, drill the hole for the pin, then weld it on.
Eassy peezy.
HarryVanderpool
Gold Member
On second thought, there is no need to remove the shaft.
Just set the plow in your shop and repair it right in place.
Just set the plow in your shop and repair it right in place.
Gary Fowler
Super Star Member
- Joined
- Jun 23, 2008
- Messages
- 11,917
- Location
- Bismarck Arkansas
- Tractor
- 2009 Kubota RTV 900, 2009 Kubota B26 TLB & 2010 model LS P7010
If yo can weld (or get it to a welding shop) it looks to be an easy fix. I think you will have to cut off the flat pieces that broke, fab up a new piece from a piece of 1/2" plate, drill a hole for a new bolt on pin and weld the plate back to the pipe cross member. Shouldn't take more than an hour at a shop to fix.
