# of zerks on 3710

[Joesgoats]

My manual states there should be 9 grease fittings on my L3710. I could only find 7. They said 2 on the knuckle, I found 1. It said 2 on the axle support, found 2. Said 2 on the power steering pump, I found 1.

Any idea where the missing ones are?

 

[DavidH]

My manual shows 2 fittings on top link of 3ph, 2 fittings on right hand lifting rod of 3ph, 1 fitting on top link bracket of 3ph, 2 fittings on power steering cylinder, and 2 fittings on wheel knuckles of 2wd 3710's. My manual says nothing of axle support zerks.

DaveH

 

[Joesgoats]

Dave,

That is what my manual says as well. I have 4wd so the fittings are slightly different. But I can only find one zerk for the power steering. There are two fittings in the area where the axle sits, one in front and one behind (I called those axle supports). The rear fittings are the same. So there are 5 in the rear, and should be 4 in front for 4wd. I definitely could only find one for the power steering. Are some well concealed?

Joe