fatbassman
New member
- Joined
- Mar 5, 2019
- Messages
- 7
- Tractor
- Kioti NX6010
I've been looking into getting a top and tilt setup for my Kioti NX6010. Running into a few problems.
The top link on my tractor is Cat1 at it's connection point to the tractor, and Cat2 on the implement side. Not sure if this is normal or strange. Either way, its no real problem. Though the hydraulic top link is Cat2 on both ends, a reducer bushing on the tractor side makes everything ok.
It's the side link that's causing me some problems. The places I've asked have hydraulic cylinders with 15/16th holes in both the upper and lower forks. My tractor has has 11/16th holes. Is there no standard pin size for a Cat2 3 point?
Thoughts? What's the best course of action?
1) Keep shopping?
2) Drill out my lift arms, and use a bushing if I switch back to the manual link arm? Providing I can find a 15/16 to 11/16 reducer bushing....
3) Spend more money and take them somewhere to be fixed? (I'm this would be a big job?)
The top link on my tractor is Cat1 at it's connection point to the tractor, and Cat2 on the implement side. Not sure if this is normal or strange. Either way, its no real problem. Though the hydraulic top link is Cat2 on both ends, a reducer bushing on the tractor side makes everything ok.
It's the side link that's causing me some problems. The places I've asked have hydraulic cylinders with 15/16th holes in both the upper and lower forks. My tractor has has 11/16th holes. Is there no standard pin size for a Cat2 3 point?
Thoughts? What's the best course of action?
1) Keep shopping?
2) Drill out my lift arms, and use a bushing if I switch back to the manual link arm? Providing I can find a 15/16 to 11/16 reducer bushing....
3) Spend more money and take them somewhere to be fixed? (I'm this would be a big job?)
