k0ua
Epic Contributor
I think you have it figured out... I have some Kubota parts on my Kioti, but orange on orange is OK.. orange on blue... uh not so much!
Now an Official member of the LS forum
- Thread starter breadtrk
- Start date
- Views: 4844
I think you have it figured out... I have some Kubota parts on my Kioti, but orange on orange is OK.. orange on blue... uh not so much!
AaronS
Platinum Member
- Joined
- May 3, 2008
- Messages
- 673
- Location
- Santa Claus, Indiana
- Tractor
- LS XR4046HC, New Holland Boomer 1020
That's why they sell paint! It sure looks like both levers are connected to the same pivot point....one for the front and one for the rear. Should be simple enough to fab up if there is a space to route it out of the cab. I'll have to look into this also when I get my 4046.
It sure looks like both levers are connected to the same pivot point....one for the front and one for the rear. Should be simple enough to fab up if there is a space to route it out of the cab. I'll have to look into this also when I get my 4046.
OP
breadtrk
Platinum Member
Just looked, should be very easy to add on mine. Every thing at the valve is clear with no obstructions from the rear and the cab support structure is in the perfect spot to attach a pivot bracket.
I'll have to make kits to sell to others.....
I'll have to make kits to sell to others.....
