NH B40 toolbox kit on LS R4041 pics

boomer632 · Sep 6, 2012

Took about 10 minutes to install. Just goes over the ROPS bolts then reinstall nuts. The toolbox has a slot in the back where a metal tab from the mount passes through. A small lynch pin holds the box on the mount. If you need to remove the box.. pull the pin and its off.

rwork · Sep 7, 2012

That's pretty slick! Did you mention that you can purchase the mounting kit separately? I could see getting the bracket, and mounting my own box.

Sent from my iPad using TractorByNet

boomer632 · Sep 7, 2012

Yes you can just get the bracket by itself. I didnt know how the kit was configured so I had to be the guinea pig and get both.. Im not sure the kit will fit a 3039 though. I know it will fit the 4041 and 4047.

rwork · Sep 7, 2012

I'm going to take a look at mine this weekend. That bracket should be easy enough to fabricate. I'd like to get something like that on mine as well.
I'm also trying to figure out a place to put a chain box; that would be handy.
Either way, your setup up looks great. Nice to have a place for your gloves and a few tools! Enjoy!