bjr
Veteran Member
Plunger is out of machine setting on a pallet.
These bearing are shown as item 10 on the parts page. There is also a pipe plug shown in the ends of the bearings. The issue is removal. There's a 3/16" allen wrench head (socket head) in the end but I can't get them to budge. Any tips or tricks to get these bearing off the studs. The stud if ordered is shown at $84.56 I think it takes 6 of these, kinda spendy. Help on bearing removal is appreciated. And yes I have the "operators Manual" but not much help on this problem. bjr
These bearing are shown as item 10 on the parts page. There is also a pipe plug shown in the ends of the bearings. The issue is removal. There's a 3/16" allen wrench head (socket head) in the end but I can't get them to budge. Any tips or tricks to get these bearing off the studs. The stud if ordered is shown at $84.56 I think it takes 6 of these, kinda spendy. Help on bearing removal is appreciated. And yes I have the "operators Manual" but not much help on this problem. bjr