New xr4046,where to get parts in canada

[Rc4510]

Got new xr 4046h with cab,so far so good,not sure about getting parts or filters ect here in Alberta Canada.havnt had much luck finding filter numbers yet,still waiting for a stereo plug adapter and havnt been able to find a switch for work light yet,my dealer is a couple hrs away but might have to contact them.everything else has been good.love the cab

 

[the whispering oaks farm]

Got new xr 4046h with cab,so far so good,not sure about getting parts or filters ect here in Alberta Canada.havnt had much luck finding filter numbers yet,still waiting for a stereo plug adapter and havnt been able to find a switch for work light yet,my dealer is a couple hrs away but might have to contact them.everything else has been good.love the c
I have the same tractor, I had the same problem, they sent me the filters from the factory, and I had to wire the the stereo from a schematic.

 

[the whispering oaks farm]

here is the diagram that I got. it worked ok.

 

[George2615]

here is the diagram that I got. it worked ok. View attachment 361534

I found the radio harness in the cab roof on mine when I had the roof tipped up to run my flashing strobe wiring. I just installed my radio today. It wasn't too bad to figure out. Just traced the color coded speaker wires back to the plug. Used a test light to determine the battery plus (to retain memory) and ignition on wires and the ground.

 

[George2615]

Got new xr 4046h with cab,so far so good,not sure about getting parts or filters ect here in Alberta Canada.havnt had much luck finding filter numbers yet,still waiting for a stereo plug adapter and havnt been able to find a switch for work light yet,my dealer is a couple hrs away but might have to contact them.everything else has been good.love the cab

I'm still waiting for LS to update the Canada online site for manuals. This site (lstractorcanada.ca/Owners--Parts-Manuals.htm) does have downloadable parts manuals for some models. I'm sure those in Canada can order parts there as well. I also ordered my own 1"x2" snap in rocker switches to install. I'll have to rewire the existing harness plug to fit my switches.

 

[the whispering oaks farm]

I'm wondering what did you have to do to tip your roof up?

 

[George2615]

I'm wondering what did you have to do to tip your roof up?

two nuts in front behind thé work lights and two on the sides above the doors. then unplug the worklight wiring and the top will lift up to allow Access.

 

[the whispering oaks farm]

Thanks, that worked.

two nuts in front behind thé work lights and two on the sides above the doors. then unplug the worklight wiring and the top will lift up to allow Access.