New TN member with lots of questions

   / New TN member with lots of questions #1  

robhannan

New member
Joined
Dec 8, 2017
Messages
6
Location
Linden, TN
Tractor
Kubota L3450
I am a new member today. Bought a very nice new Kubota L4701 HST-R1 in Feb 2016 and loved it, but since I am looking to sell my 196 acres in TN I decided to sell it in August while it only had 45 hours. Then, I missed having a tractor so I bought a 1993 Kubota L3450-DT in Alabama with 600+ hours and a front loader and bucket. Runs good and while it has wear and tear, it was a good purchase I think. Here are my problems. I fixed the fuel gauge (connector to sensor top of tank was disconnected), no tail light (bought a new tail and a new rear wiring harness and now got a tail light), hazard lights not working (bought a new rear wiring harness, and a new combination switch for dash, and checked 10A fuse for hazard lights, but still no indication of power flow to the connectors on the wiring harness to the hazard lights). Also, need a SMV bracket to mount the SMV sign. Ordered a new fuel stop solenoid because key off did not stop engine. All advice appreciated. I am bew to diesel and tractors but smart and soak up got advice.
 
   / New TN member with lots of questions #2  
I am a new member today. Bought a very nice new Kubota L4701 HST-R1 in Feb 2016 and loved it, but since I am looking to sell my 196 acres in TN I decided to sell it in August while it only had 45 hours. Then, I missed having a tractor so I bought a 1993 Kubota L3450-DT in Alabama with 600+ hours and a front loader and bucket. Runs good and while it has wear and tear, it was a good purchase I think. Here are my problems. I fixed the fuel gauge (connector to sensor top of tank was disconnected), no tail light (bought a new tail and a new rear wiring harness and now got a tail light), hazard lights not working (bought a new rear wiring harness, and a new combination switch for dash, and checked 10A fuse for hazard lights, but still no indication of power flow to the connectors on the wiring harness to the hazard lights). Also, need a SMV bracket to mount the SMV sign. Ordered a new fuel stop solenoid because key off did not stop engine. All advice appreciated. I am bew to diesel and tractors but smart and soak up got advice.

My advice with any electrical issue is to always check all your grounds first... :popcorn:
 
   / New TN member with lots of questions #3  
Welcome to TBN from Lincoln county!
 
   / New TN member with lots of questions #4  
:welcome:

:tractor: I'm going to move this thread on over to our Kubota section.
 
   / New TN member with lots of questions
  • Thread Starter
#6  
Thank you.
 

Tractor & Equipment Auctions

Woods Brushbull 720 3 pt Mower (A50514)
Woods Brushbull...
2013 Kubota M9960 (A50120)
2013 Kubota M9960...
(11) 2 PLUG VALVES (A52472)
(11) 2 PLUG VALVES...
AGT Agrotk 680 Drop Hammer Attachment (A47384)
AGT Agrotk 680...
ST225/75R15 Tires (A47384)
ST225/75R15 Tires...
2016 BMW X5 sDrive35i SUV (A50324)
2016 BMW X5...
 
Top