Struckman
New member
Hello to fellow forum members.
First time on board and hope to learn from the veterans about my just purchased Struck MT2000 with front bucket and a 18 hp Tecumseh motor.
The dozer has been sitting in a shed for 10-yrs. prior to my purchase.
I got it running and the motor sounds fine, but the transaxle appears to hardly engage.
After letting it run for over an hour, I was able to drive it up onto my trailer to get it home.
Both gas tanks (one on each side of the seat) are rotted out so I mounted a 1-gallon law mower tank, gravity fed to operate it for now.
Most of the hydraulic hoses are pretty far gone, I had to replace one broken one before I could lift the bucket to get it out of the shed.
My biggest concern is the operating condition of the clutch and transaxle
I'll post some photos to the Struck forum when I figure out how to do that
First time on board and hope to learn from the veterans about my just purchased Struck MT2000 with front bucket and a 18 hp Tecumseh motor.
The dozer has been sitting in a shed for 10-yrs. prior to my purchase.
I got it running and the motor sounds fine, but the transaxle appears to hardly engage.
After letting it run for over an hour, I was able to drive it up onto my trailer to get it home.
Both gas tanks (one on each side of the seat) are rotted out so I mounted a 1-gallon law mower tank, gravity fed to operate it for now.
Most of the hydraulic hoses are pretty far gone, I had to replace one broken one before I could lift the bucket to get it out of the shed.
My biggest concern is the operating condition of the clutch and transaxle
I'll post some photos to the Struck forum when I figure out how to do that
