New Holland TC loader problems

[dczaikowski]

Parked my 02' TC40D with a 16LA loader in the garage last night and everything worked fine, went to move it tonight and the loader would not move up or curl back. Seemed like down and dump work as far as gravity but with no force. Fluid level is good, 3 PT works, aux rear remote works and tranny works. Any ideas??

 

[jayste]

Parked my 02' TC40D with a 16LA loader in the garage last night and everything worked fine, went to move it tonight and the loader would not move up or curl back. Seemed like down and dump work as far as gravity but with no force. Fluid level is good, 3 PT works, aux rear remote works and tranny works. Any ideas??

Welcome to TBN! You might try your question in one of the tractor or implement specific forums here on TBN. Post a thread I guarantee you'll get some help.:thumbsup:

 

[housemasters]

Check your quick disconnects.

 

[jinman]

Check your quick disconnects.

+1, disconnect and reconnect to be sure

 

[RobertN]

+2
Did that with my old Kubota, although it would kill the motor; deadheaded the pump. Different setup though.

Check your quick disconnects.

 

[tchall]

Parked my 02' TC40D with a 16LA loader in the garage last night and everything worked fine, went to move it tonight and the loader would not move up or curl back. Seemed like down and dump work as far as gravity but with no force. Fluid level is good, 3 PT works, aux rear remote works and tranny works. Any ideas??

It it was cold there I'd have the solution.... my TC 30 gets reluctant to move the hydraulics when the few droops of water in the system freeze in the lines...

I've had to wrap the tractor in a tarp and get it nicely warmed up to be able to use it when that happened...

Of course minus 16 IS not really considered operating temps for this equipment...<G>

 

[jimmysisson]

Just guessing, would this act this way if the position control were in the detent?
JIm