OP
kubotacres
Gold Member
will do and reply back tomorrow.
New Goodies installed on the L3200
- Thread starter kubotacres
- Start date
- Views: 9402
-
- Tags
- kubota l3200
will do and reply back tomorrow.
Bob77064
Elite Member
Good looking mods.
Robert_in_NY
Super Member
- Joined
- Aug 1, 2001
- Messages
- 8,552
- Location
- Silver Creek, NY
- Tractor
- Case-IH Farmall 45A, Kubota M8540 Narrow, New Holland TN 65, Bobcat 331, Ford 1920, 1952 John Deere M, Allis Chalmers B, Bombardier Traxter XT, Massey Harris 81RC and a John Deere 3300 combine, Cub Cadet GT1554
Thank you, I appreciate it
First, congrats on getting the jerky hitch fixed. Using a boom pole without a FEL is the worst case scenario...
I bought the stabilizer kit ($185 IRC) but didn't like how loose they were when not hooked up to something. Are yours tight when not connected to an implement? I have to try them again...
I bought the stabilizer kit ($185 IRC) but didn't like how loose they were when not hooked up to something. Are yours tight when not connected to an implement? I have to try them again...
OP
kubotacres
Gold Member
The OD of the flange is exactly 1". The ID is exactly 1/2". This is for the flange that attaches to the tractor close to the rear axle.
OP
kubotacres
Gold Member
normally i always have something attached to the 3pt. Actually I can't remember the last time I have actually drove around without something attached. However considering the way the holes match up, i don't see why whether with or without a attachment it would be loose. But like i said before i always have something attached, so I really can't speak from experience.. But I can say this, the turnbuckles were gone the first hr of seat time. I hated them from the start and being they stayed loose they always made a loud creaking sound swaying back/forth. I guess it's what you get used too, Every tractor I've been on (except for the old Jubilee) has had the stabilizers..