Need to override L3400 seat safety switch circuit

[TheCommissioner]

I replaced the seat safety switch in my L3400 HST and in the process broke a wire that connects to the female side of the plastic connector, i.e. a wire coming out of the harness. Of course the new switch is useless until I can reconnect the broken wire. Unfortunately the wire broke off flush with connector and there is not enough of a tail to work with. Added to the problem is the location of the tractor; not a good place to work on it. I need to move the tractor to a better spot in order to repair the broken wire. Any ideas on how to close the circuit in order to disable the engine cut out? Thanks guys!

 

[TheCommissioner]

After giving this situation some thought, the best course of action (and least expensive since a new wire harness might as well be made of gold) is to wire the switch directly into the harness and eliminate the plastic connectors. I can use those heat sensitive automobile wire splices. The downside is the connectors are gone for good but the upside is the safety switch remains functional.

 

[herringchoker]

That's what I would do.

 

[carmedic310]

If its a 2 wire switch all you have to do is jump the 2 wires together to make the circuit