My New NX4510

[NetbyTractor]

I will let you know since yours is a 2017 like mine, that I just had a warranty defrost kit fix installed to take care of a no heat w/ AC on condition.

While I was plowing snow this past year, I would have to cycle between the cold AC (to get windows defogged) back to heat only to warm ME back up. The fix is supposed to blow hot air while the AC compressor is engaged just like your car. If I turned the hot/cold dial all the way to hot w/ AC button on, I still only got cold air. Took them a little over an hour and they did it in my driveway rather than hauling into the shop.

This was a fantastic hint. Thank you very much. I probably wouldn't have realized it until next winter, and then I would be out of warranty. I took it to the dealer, and they got the ok to fix it. Otherwise would have been a costly repair. Thanks again.

 

[thekkfan]

You are most welcome! :drink:

 

[justman777]

All, not to revive a dead thread, but thought it would be helpful to post the revised AC control part number. This is what allows the compressor to be on when the cab AC is on heat.

The part number is TE16-A0083A. My dealer asked the regional service director about it, and he knew what it was right away.

Hope this helps someone!

 

[NetbyTractor]

BTW.. still happy with the NX. Added a Kb2485 backhoe and about 15 hours so far.

 

[thekkfan]

...... the revised AC control part number. This is what allows the compressor to be on when the cab AC is on heat.

The part number is TE16-A0083A.

Thanks for posting up.

 

[justman777]

No problem! Thought I could contribute somewhat, considering I've benefited from everyone else's posts on this forum.