My Biggest Gripes About My Mahindras
- Thread starter Ledgemere Farm
- Start date
mike69440
Elite Member
- Joined
- Jun 2, 2005
- Messages
- 3,093
- Location
- Central NH (God's Country)
- Tractor
- 1984 Kubota B7200D (Sold 2015,) 2005 L39 Kubota, 2006 RTV 900 1997 Komatsu PC75UU2E w/ Thumb & Blade, 2013 Mahindra Max28XL Shuttle
Good tip on the Paint.
Mitsubishi electrical is not quite as bad as Lucas, but close. Connectors corrode, not water tight.
Plastic quality is UV sensitive and in general not great.
Beware using your axle lock.
How much do your axles overhang?
I fiberglass repaired shifter gate that I caught my pants on.
Both tractor an loader is quite flexy.
Then again I comparing to old tractors and my Kubota TLB.
Mitsubishi electrical is not quite as bad as Lucas, but close. Connectors corrode, not water tight.
Plastic quality is UV sensitive and in general not great.
Beware using your axle lock.
How much do your axles overhang?
I fiberglass repaired shifter gate that I caught my pants on.
Both tractor an loader is quite flexy.
Then again I comparing to old tractors and my Kubota TLB.
OP
Ledgemere Farm
Veteran Member
I definitely agree with the electricAl connections and that disconnecting them and adding dielectric grease during fair weather will save a lot of agony later on. If money/dealerships and features were all on the same plane, I would buy a Kubota hands-down.
mike69440
Elite Member
- Joined
- Jun 2, 2005
- Messages
- 3,093
- Location
- Central NH (God's Country)
- Tractor
- 1984 Kubota B7200D (Sold 2015,) 2005 L39 Kubota, 2006 RTV 900 1997 Komatsu PC75UU2E w/ Thumb & Blade, 2013 Mahindra Max28XL Shuttle
I would love to own new dealer serviced stuff to take the struggle out of life. Alas, poverty me.
See post 22
Used L45 looking for opinions on the matter
I decided to check back in at the dealer and the L45 has been sold. No surprise really...Lmk if you decide to sell yours! If you decide to sell the BH77 separately let me know, I'm in KY as well.
www.tractorbynet.com