Miller Big 40 Welder

jrc55 · Jun 9, 2020

Searched but no luck, was probably doing it wrong. Welder has been sitting for a while, got the Red Seal gas engine running good but no power from the generator.

So far I've cleaned the slip rings and brushes, still nothing on the volt meter. Looked for chewed on wires or broken ones, didn't see anything.

Next chance I was going to ohm the wires from the brushes to the square blocks.

Checked Utube not much help.

Any ideas or help would be appreciated, it did work when I last used it many moons ago.

Thanks, Joe

mrmikey · Jun 9, 2020

Post on WW, WeldingWeb - Welding Community for pros and enthusiasts good bunch there will probably help if you don't get any replies here.............Mike

jrc55 · Jun 10, 2020

Thanks! I'll check them out.

jrc55 · Jun 10, 2020

mrmikey said:
Post on WW, WeldingWeb - Welding Community for pros and enthusiasts good bunch there will probably help if you don't get any replies here.............Mike

Thanks again "mrmikey" Ive gotten several leads on what to check for from the Welding Web.

Joe