burtman4
New member
I have a MF253 with a Greatbend 330 loader that is run off the single rear remote on my tractor. Everything currently works fine. I recently acquired a batwing mower that I want to use in my horse pasture and I need the rear remote. Trying to figure out how to re-plumb my loader or ??? My friend has a MF243 and MF383 with MF loaders on them with both as installed from the dealer. I see that both of his loaders are plumbed in series prior to the rear remotes and don't use a PB port. Pressure goes to the loader and then the out from the loader goes to the in to feed the rear remote allowing usage of both. In reading it sounds like this can damage the loader valve, through both these tractors have 1500+ hours with this configuration. I am confused on if this is an option for me, or do I need to go another route. Any advice would be helpful.
