Measurements needed....Chain holder for M7060

[inode]

I'm wanting to build a chain holder out of schedule 40 pipe and using Oatey Grippers for end caps. I am not close to my tractor currently. Can someone measure the following on their LA1154 loader:

1) Measure the inside diameter and length of the hollow tube on loader just below above bucket?
2) Measure the inside diameter and length of hollow tube just below and in front of foot platform?


This is what I want to make:

FARM SHOW Magazine - The BEST stories about Made-It-Myself Shop Inventions, Farming and Gardening Tips, Time-saving Tricks & the Best Farm Shop Hacks, DIY Farm Projects, Tips on Boosting your farm income, time-saving farming advice, farming tractors

Thanks in advance.

 

[inode]

Anyone?

 

[deserteagle71]

The tube at the front of the loader measures 4-7/16" ID X 43-9/16" long. The tubes by the cab measures 4-15/16" ID X 11-5/8" long (but they're probably metric!).

I use the tube at the front of the loader for tools all the time...shovels, pitchforks, long bars all ride around in there depending on what I am doing.

 

[inode]

Thank you very much.