massey 135 no power to tansmission or hydraulics

   / massey 135 no power to tansmission or hydraulics #1  

sbmassy

New member
Joined
Jan 12, 2016
Messages
1
Location
ontario
Tractor
massey ferguston 135/allis chalmers d17
recently bought a 135 just got it running, but I cant seem to get any power to the transmission when you engage/disengage clutch pedal you can tell the engine is taking a load. you can shift through all the gears without engaging the clutch... hydraulics do not work for 3pth lift and PTO does not engage
 
   / massey 135 no power to tansmission or hydraulics #2  
recently bought a 135 just got it running, but I cant seem to get any power to the transmission when you engage/disengage clutch pedal you can tell the engine is taking a load. you can shift through all the gears without engaging the clutch... hydraulics do not work for 3pth lift and PTO does not engage
Have you checked your hydraulic fluid level? If your fluid has water in it can prevent the hydraulic pump from working. There is a drain plug on the bottom just under the operators seat. Loosen and drain a small amount out to check for color. Water reacts with hydro fluid just as an automobile and creates a murky fluid thus congestion the fluid from entering the pump. The internal transmission cavity may need flushing. The refill port is just to the left of the shifter on top. Do you have a operators manual?
 
   / massey 135 no power to tansmission or hydraulics #3  
recently bought a 135 just got it running, but I cant seem to get any power to the transmission when you engage/disengage clutch pedal you can tell the engine is taking a load. you can shift through all the gears without engaging the clutch... hydraulics do not work for 3pth lift and PTO does not engage

Does your unit have Multi-Power? BobG in VA
 
   / massey 135 no power to tansmission or hydraulics #4  
Open the inspectioncoven under the bellhousing and look if the shafts is turning when engine is running . You my have a clutch to overhaul .
 
   / massey 135 no power to tansmission or hydraulics #5  
recently bought a 135 just got it running, but I cant seem to get any power to the transmission when you engage/disengage clutch pedal you can tell the engine is taking a load. you can shift through all the gears without engaging the clutch... hydraulics do not work for 3pth lift and PTO does not engage

Sounds like your clutches needs adjusting or replacement or you have a broken shifting fork.
 

Tractor & Equipment Auctions

2013 Jeep Patriot Sport 4WD SUV (A50324)
2013 Jeep Patriot...
JCB 409 AGT4 WHEEL LOADER (A51246)
JCB 409 AGT4 WHEEL...
2011 JOHN DEERE 6115D (A52472)
2011 JOHN DEERE...
2016 (INOPERABLE) FREIGHTLINER SD122 (A52472)
2016 (INOPERABLE)...
2018 Dodge Ram 3500 4x4 Utility Flatbed Truck - HEMI Gas, Gooseneck Hitch, Southern Truck (A52748)
2018 Dodge Ram...
UNVERFERTH 330 - 22-INCH EXTENTSION TUBE FOR BASE AND WING ASSEMBLY FOR RIPPER (A52748)
UNVERFERTH 330 -...
 
Top