raysmithtx
New member
- Joined
- Sep 6, 2018
- Messages
- 12
- Location
- Fort worth, texas
- Tractor
- Mahindra 4025 and a Bobcat E35 excavator
Mahindra 4025 clutch not completely disengaging
I have been lurking in the forum for quite a while and finally decided to register. This is my first post.
I bought a used Mahindra 4025 2WD a while back. At this point is has about 450 hours on it. When I depress the clutch (dual clutch) and go to put the tractor in gear, the gears grind. It will go into gear but they grind every time. It's like the clutch is not completely releasing and the gears are still slightly engaged.So my question is, is there an adjustment I can make to get the clutch to completely release so I can keep from grinding the transmission gears?
I have looked for the answer on the forum and cannot find it.
Thanks.
I have been lurking in the forum for quite a while and finally decided to register. This is my first post.
I bought a used Mahindra 4025 2WD a while back. At this point is has about 450 hours on it. When I depress the clutch (dual clutch) and go to put the tractor in gear, the gears grind. It will go into gear but they grind every time. It's like the clutch is not completely releasing and the gears are still slightly engaged.So my question is, is there an adjustment I can make to get the clutch to completely release so I can keep from grinding the transmission gears?
I have looked for the answer on the forum and cannot find it.
Thanks.
Last edited:
