Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.

   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke. #11  
I have no opinion on that, other than I wouldn't trust the sleeves. When you've exhausted all other avenues and still have air getting into the fuel (provided that is indeed the issue) then I guess I would cut those sleeves off as well and install clamps. See what difference that makes.
 
   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.
  • Thread Starter
#12  
916BB70D-859A-460D-A10E-11042E5A566E.jpeg
 
   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke. #13  
Just another thought here. As I recall many of the "air in fuel" issues I ran into on the 4025 and 4035 were eventually eliminated by adding an electric supply pump between the tank and the filter base. At the time Mahindra warranty wouldn't recognize it because Mahindra technical hadn't approved it. I did it anyway and it seemed to solve the problem.
 
   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.
  • Thread Starter
#14  
I have no opinion on that, other than I wouldn't trust the sleeves. When you've exhausted all other avenues and still have air getting into the fuel (provided that is indeed the issue) then I guess I would cut those sleeves off as well and install clamps. See what difference that makes.
Thanks
 
   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.
  • Thread Starter
#15  
Just another thought here. As I recall many of the "air in fuel" issues I ran into on the 4025 and 4035 were eventually eliminated by adding an electric supply pump between the tank and the filter base. At the time Mahindra warranty wouldn't recognize it because Mahindra technical hadn't approved it. I did it anyway and it seemed to solve the problem.
 

Attachments

  • E8A89083-5329-4A27-9552-3B6A6BB24008.png
    E8A89083-5329-4A27-9552-3B6A6BB24008.png
    1.2 MB · Views: 101
   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.
  • Thread Starter
#16  
Will this type of pump work?
 
   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke. #17  
   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.
  • Thread Starter
#18  
   / Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.
  • Thread Starter
#19  
Have another question about the fuel tank removal on my 4035. The service manual it talks about removing the steering column. Any ideas?
 
Last edited:

Tractor & Equipment Auctions

UNUSED FUTURE PC711 - 71" HYD PLATE COMPACTOR (A51248)
UNUSED FUTURE...
1996 JLG Commander CM2033 20ft Electric Scissor Lift (A51691)
1996 JLG Commander...
2019 INTERNATIONAL 4300 26FT NON CDL BOX TRUCK (A53426)
2019 INTERNATIONAL...
2022 John Deere 8RX 410 Tractor (A53342)
2022 John Deere...
2011 IC Corporation PB105 School Bus (A52377)
2011 IC...
2017 KOMATSU PC228USLC-10 EXCAVATOR (A51246)
2017 KOMATSU...
 
Top