Tommy/Ronald,
So was this a manufactering problem covered by warranty or just a failure? Would you expect that others with tractors made around the same time to have this problem as well?
It is not a warranty issue,it could have been the pump dead headed for one reason or another,pump loose,who knows.I have seen it happen on a few tractors ,but not a common problem
Tommy/Ronald,
So was this a manufactering problem covered by warranty or just a failure? Would you expect that others with tractors made around the same time to have this problem as well?
I don't see any warranty coming out of China/Jinma on this. I don't think this happens a lot verses how many Y385's are out there. For me the drive gear is a very slow moving part number.
It's hard to go into/over every step and inspection procedure when replacing a pump. But in general one should try and take note to proper fit/alignment/contact etc...... try not to assume and verify.
Like if the pump drive went to far in the slot ..... then you may need two gaskets ??
I have seen similar damage on other engine driven pumps. Sometimes I have been able to see/find/correct and sometimes ... beats the ***** out of me??
