Mowing Looks like a Slope Mower.

[SpringHollow]

Would work on the 1850 with singles but not duals.

When you are there is the time to get any of THEIR attachments because of shipping being so high. 3rd party attachments are certainly an option. I have a Lackender bucket and minihoe (digs 6' deep - thing is great).

Ken

 

[ToolcatWonka5610]

Would that mower work on an 1845?

 

[ToolcatWonka5610]

Check this out,
I found this while looking for videos on youtube:
YouTube - Skid Loader Tree Spade Bobcat Tractor Deere Fork Attachment
Is this something that could be used a Power-Trac?

 

[woodlandfarms]

Check this out,
I found this while looking for videos on youtube:
YouTube - Skid Loader Tree Spade Bobcat Tractor Deere Fork Attachment
Is this something that could be used a Power-Trac?

Yes, although the PT does not have a skid steer down pressure, and the 1845 1850 do not have the same arm strength. I think someone here has this device that he made..

 

[woodlandfarms]

The 1845 is more than likely the machine for use so it'd be used on that. An 1845 is only 69" wide so a 72" mower would work. But what hydraulic flow does the 1845 have?

15 GPM at 3000 PSI

18GPM at 3100 PSI for the 1850

Skid Steer Midsized are 17 GPM at 3K

Large sized skid can get to 30 GPM at 3K PSI

Take a look at this link http://www.tractorbynet.com/forums/hydraulics/135678-skid-steer-hydraulic-specs.html

 

[Bob999]

I purchased a PT 72" finish mower when I purchased my 1845. I used it about 10 hours and then purchased the modified Lastec deck.

I would like to sell the PT deck. It has been stored inside and as mentioned above has about 10 hours total time. I have a second, unused set of of blades for it. Location is Eastern PA.

 

[SnowRidge]

Check this out,
I found this while looking for videos on youtube:
YouTube - Skid Loader Tree Spade Bobcat Tractor Deere Fork Attachment
Is this something that could be used a Power-Trac?

Digging with a set of forks seems like a good way to bend them. You could actually weld something like that directly to a Power Trac QA plate and skip the forks. PT sells blank QA plates for each of the machines. The 1445 plate is $300.

Some folks on here make their own QA plates for a lot less than PT charges. In any event, if your dad does end up buying a Power Trac, I strongly suggest he get one of the blank QA plates at the same time. It is very handy to have one lying around in case you need to cobble something up in a hurry.

 

[ToolcatWonka5610]

We plan to buy a spare QA plate or two.
But if you notice that Quick Spade can also be used on a bucket.
That may work on a PT 1845.

 

[ToolcatWonka5610]

I purchased a PT 72" finish mower when I purchased my 1845. I used it about 10 hours and then purchased the modified Lastec deck.

I would like to sell the PT deck. It has been stored inside and as mentioned above has about 10 hours total time. I have a second, unused set of of blades for it. Location is Eastern PA.

How much you want for it?